为对等连接配置 WireGuard 和 IPFS

Question

我已经成功地在两台 PC 之间建立了 WireGuard 连接，并且可以在它们之间执行 ping 操作. 但是，我遇到了一个问题，那就是另一台电脑在IPFS上没有以群对等体的形式出现. 我怀疑可能需要进行一些必要的配置更改. 具体而言，我不确定是否需要修改WireGuard设置、IPFS配置设置或WiFi路由器上的防火墙设置. 我应该对路由器设置或配置文件进行任何具体更改吗？是否建议禁用路由器的防火墙？如有任何指导，将不胜感激.

IPFS moderator · Answer

To add other nodes for peering with your local WireGuard address, you can follow these steps: Open the configuration file of your WireGuard setup. This file is typically located in the /etc/wireguard/ directory. Locate the section in the configuration file where you define the peers. This section will contain information about the peers you are currently peering with. Add a new entry for each node you want to peer with. Each entry should include the following information: PublicKey: The public key of the node you want to peer with. This key is typically generated when setting up WireGuard on the remote node. AllowedIPs: The IP range that you want to allow traffic from the peer. This can be a specific IP address or a range of IP addresses. Endpoint: The IP address and port number of the remote node. This is the address that your node will use to establish a connection with the peer. Heres an example of how a peer entry might look like in the configuration file: [Peer] PublicKey = AllowedIPs = Endpoint = : Save the configuration file and exit. Restart the WireGuard service to apply the changes. You can do this by running the following command: sudo systemctl restart wg-quick@ Replace `` with the name of the WireGuard interface you are using. By adding these entries to your WireGuard configuration file, you will be able to establish peering connections with the specified nodes using your local WireGuard address. For more information, you can refer to the official documentation.

帖子

分享您的知识。

为对等连接配置 WireGuard 和 IPFS

答案

你知道答案吗？

赚取你的 1000 Sui 份额